Machining Demo Archives - Page 4 of 5 - KYOCERA SGS Precision Tools Group

MFH-RAPTOR Milling Demo – Short Machining Clip

See KYOCERA’s MFH-RAPTOR cutter machining a metal workpiece in this six-second demonstration. The close-up clip shows the cutter in operation, with chips leaving the cut inside the machine.

MEAS Aluminum Milling Cutter Machining Demo

Watch KYOCERA’s MEAS high-efficiency milling cutter machine an aluminum workpiece. This short demonstration provides a close-up view of the cutter in operation and chips leaving the pocket as machining progresses.

KPK Jet Coolant-Through Cut-Off Blade Demo in 4137 Steel

Watch KYOCERA’s KPKB32-3JCT cut-off blade machine 4137 steel with internal coolant. The demo uses a PKM30N-025PM PR1625 insert at 780 rpm, approximately 390 sfm, with feed reduced near the center of the workpiece.

High-Feed Milling Applications with MFH-RAPTOR

Watch KYOCERA’s MFH-RAPTOR milling series demonstrate peripheral cutting, slotting, and pocketing. This extended machining video shows high-feed milling operations with on-screen cutting conditions, including a five-flute MFH-Mini end mill cutting a metal workpiece.

Finishing 1045 Steel – Cermet vs. Carbide, Coated vs. Uncoated

Compare CCX CVD-coated cermet, PV710 PVD-coated cermet, TN620 uncoated cermet, and CA515 CVD-coated carbide when finishing 1045 steel. This side-by-side evaluation examines insert choices and cutting speeds for reducing finishing cycle time within surface-finish requirements.

Hard Turning a Shaft with KBN020 – Continuous to Interrupted Machining

Watch KYOCERA KBN020 hard turn a 4118H steel shaft at 62 HRC, moving from continuous to interrupted machining. The dry-cutting demo runs at 390 sfm and 0.008-inch depth of cut, with feed reduced from 0.007 to 0.006 ipr for interruption.

KGZ Small Diameter Cut-Off in 6061 Aluminum – PG Chipbreaker

Watch KYOCERA KGZ cut off a small-diameter 6061 aluminum workpiece with the sharp-edged PG chipbreaker. This demonstration runs at approximately 980 sfm and 0.0012 ipr, highlighting low cutting force for aluminum alloy machining. Coolant is recommended.

KGZ Small Diameter Cut-Off in 304 Stainless Steel – PM Chipbreaker

Watch KYOCERA KGZ small-diameter cut-off machining in 304 stainless steel with the versatile PM chipbreaker. This short demo shows coolant-fed machining at approximately 330 sfm and 0.004 ipr, using a PR2035-grade insert on a 0.551-inch-diameter workpiece.

Z-Carb XPR in Action: Milling, Ramping and Plunging

Watch the SGS Z-Carb XPR end mill rough, finish, ramp, pocket, slot, and plunge in 4140 steel. The demonstration shows cutting parameters for multiple operations and explains how its variable geometry and wiper flats support the machining process.

Categories

Tags

Categories

Tags

Search Articles

Categories

Tags

Share

Spindle Spotlight Newsletter

Popular Articles